This is a weird bug for me.
My OP-Z is an early one. If I set it in manual save mode, wish this was the default mode, I can manual save on every project except project 1.
Project 1 auto saves fine , and will show the manual save animation , but if I reboot project 1 data is gone.
All other projects work normally.
Have done a factory reset, deleted all patterns, latest firmwear.
I’d think it was bad memory, but it seems to auto save ok.
Any ideas ? I’m done with losing my data and not am a project down unless I keep it in Auto save mode, which I don’t like bc the encoders nudge easily.