The legs of the headphone jack have lifted off of the connector board. As a result, there is no sound from the speaker. I removed the jack but couldn’t salvage all of the small pads. Is this repairable in some way?
yowza
its gunna be tough since most of the pads have lifted off the board.
if u can trace where each of hte pads go
and the jack itself is still good
u can run wires from each of the legs of hte jack
to where they are supposed to connect to on the board.
essentially bypassing the broken pads.
then somehow secure the jack into its spot again so it dont wiggle around
not the prettiest but its possible.
otherwise u most likely looking at a new connector board